-> Hier kostenlos registrieren
Guten Morgen zusammen,
ich benötige mal wieder Hilfe und hoffe mir kann jemand weiterhelfen?
Ich bin noch recht unerfahren beim programmieren als erste Info und bin mir deshalb nicht ganz sicher wie ich jetzt bei folgendem Problem vorgehen soll.
Ich habe folgende Bauteile:
1x CPU 315-2 PN/DP 6ES7 315-2EH14-0AB0
1x Sinamics Control Unit CU320-2 PN 6SL3040-1MA01-0AA0
1x Sinamics S120 Smart Line Module 6SL3130-6AE15-0AB0
2x Sinamics S120 Double Motor Module 6SL3120-2TE13-0AA3
Die Compactflash Card ist auch vorhanden und schon gesteckt!
Ich soll jetzt eine HW Konfig hierfür erstellen. Die Verbindung soll als Profinet aufgebaut werden.
Die CPU hab ich schon projektiert in der HW Konfig und auch schon das Profinet-IO-System.
Wie aber muss ich jetzt und vor allem was muss ich jetzt von den Antrieben in der HW Konfig projektieren?
Bin da wirklich total hilflos und hab keine Idee wie das gehen soll?
Ich bitte euch deshalb um eure Mithilfe.
Danke schonmal und Gruß
Stephan
ich benötige mal wieder Hilfe und hoffe mir kann jemand weiterhelfen?
Ich bin noch recht unerfahren beim programmieren als erste Info und bin mir deshalb nicht ganz sicher wie ich jetzt bei folgendem Problem vorgehen soll.
Ich habe folgende Bauteile:
1x CPU 315-2 PN/DP 6ES7 315-2EH14-0AB0
1x Sinamics Control Unit CU320-2 PN 6SL3040-1MA01-0AA0
1x Sinamics S120 Smart Line Module 6SL3130-6AE15-0AB0
2x Sinamics S120 Double Motor Module 6SL3120-2TE13-0AA3
Die Compactflash Card ist auch vorhanden und schon gesteckt!
Ich soll jetzt eine HW Konfig hierfür erstellen. Die Verbindung soll als Profinet aufgebaut werden.
Die CPU hab ich schon projektiert in der HW Konfig und auch schon das Profinet-IO-System.
Wie aber muss ich jetzt und vor allem was muss ich jetzt von den Antrieben in der HW Konfig projektieren?
Bin da wirklich total hilflos und hab keine Idee wie das gehen soll?
Ich bitte euch deshalb um eure Mithilfe.
Danke schonmal und Gruß
Stephan