Hallo,
ich prüf das mal bin aber der Meinung
die tty's sollten jetzt schon gehen... habe keine Platine da womit ich testen könnte.
RS-485 Schnittstelle - müsste funktionierenRS-232 (‘serielle’) Schnittstelle -- müsste funktionieren
5 Eingänge an Schraubanschlüssen, zusätzlich an einem "Joystick" auf der Platine - wie angebunden (über GPIO's ???) dann müsste das jetzt auch gehen
2 Ausgänge 5 Volt mit LEDs (grün und rot) an Schraubanschlüssen - GPIO's
I2C Bus - (denke der ist für die RTC???)
Echtzeituhr (RTC) mit Batterie - das betrifft ja erst mal Linux sollte also auch kein Thema sein
Hat jemand so ein Teil und kann es verifizieren?
Wenn man das script zur Installation aufruft kommt:
apt-get returned the error code '100'.
Failed to install the Rs-485 Device Driver package for your kernel version.
If apt-get couldn't find a package for your kernel version, you have 3 options:
1) Consider switching to a kernel version for which a rs-485 driver package
has been built (e.g. 3.10.19+ #600)
2) Post your kernel version (uname -a) on our forums
(
http://www.amescon.com/forum) and ask for a driver package for your kernel
3) Download the kernel module source and built the module yourself
(
https://github.com/amescon/raspicomm-module.git)
exporting gpio 4
exporting gpio 22
exporting gpio 23
exporting gpio 24
exporting gpio 25
exporting gpio 18
exporting gpio 27
i2c already configured
also würde ich mal meine Aussage korrigieren und sagen RS-232 könnte gehen, für RS-485 braucht man wohl eher einen bestimmten kernel& passendes kernelmodul
Grüße