-> Hier kostenlos registrieren
Hi i have Beckhoff (CX5020-0120-M310) (profibus master) with TC3.1 and want communicate with Siemens Profibus ET 200S (IM151 IM-1AA04_0AB0) DPV1.
All modules works on ET200s except 1SI RS232 (6ES7138-4DF01-0AB0). When i triggered Barcode scaner i have one bit ON and no more data from 1SI module.
on Array (0..15) of words
0.#0000000000000000
1.#0000000000000001 <= this bit is ON after trigered pushbutton on scaner
2.#0000000000000000
3.#0000000000000000
..#0000000000000000
..#0000000000000000
15#0000000000000000
This Same ET200S with this same configuration i have tested with Siemens S7-300 and it works, i can read data from Barcode scanner on the 0..31 array of byte (no WORD's like on CX5020) Siemens have On TIA portal => Communication => ET200s serial interface => Function block S_RCV i use them and i can communicate with 1SI RS232 via this block. But Twincat 3,1 don't have this block.
On ET200s i have:
1. 1SI(rs232) module (rs232 parameter is : Data - 8bit, Stop - 1 bit, Parity - NONE, Data Flow - NONE, Interface type RS232-C )
2 DO modul
3 RTD modul
4. DI
5. RO modulAny ideas where are problem? why can't read data from 1SI RS232?
I'm sorry for English language here on forum.
All modules works on ET200s except 1SI RS232 (6ES7138-4DF01-0AB0). When i triggered Barcode scaner i have one bit ON and no more data from 1SI module.
on Array (0..15) of words
0.#0000000000000000
1.#0000000000000001 <= this bit is ON after trigered pushbutton on scaner
2.#0000000000000000
3.#0000000000000000
..#0000000000000000
..#0000000000000000
15#0000000000000000
This Same ET200S with this same configuration i have tested with Siemens S7-300 and it works, i can read data from Barcode scanner on the 0..31 array of byte (no WORD's like on CX5020) Siemens have On TIA portal => Communication => ET200s serial interface => Function block S_RCV i use them and i can communicate with 1SI RS232 via this block. But Twincat 3,1 don't have this block.
On ET200s i have:
1. 1SI(rs232) module (rs232 parameter is : Data - 8bit, Stop - 1 bit, Parity - NONE, Data Flow - NONE, Interface type RS232-C )
2 DO modul
3 RTD modul
4. DI
5. RO modulAny ideas where are problem? why can't read data from 1SI RS232?
I'm sorry for English language here on forum.
