Aktueller Inhalt von AleSantaCruz

This instruction was more useful than the other one. In this case, i used the empty for the NETID string and the DEVICEID assigned by the System Manager (an integer number) I hope this is useful for other people searching for the same

Neals, it worked! I wasn't sure about the addressing, and i was using the PLC run time address instead of the EtherCAT Master Address. (under I/O Devices0=> Gerät 2 (EtherCAT)) which was actually *.*.*.*.3.1 All this is very confusing. Anyway, i managed to restart my slave. Thanks The...

Dear Neals, Thanks for the collaboration. Off course I checked the Infosys and tested the results prior to writing my doubt in this forum. I will give you more details on how i used this Function Block. Do you know any other way to deal with a Klemme when there's an error? maybe reseting it...

Hello, I have an ethercat slave device which i want to restart, since in some conditions i have failure, and I would like to restablish it to normal operation. I tried the command FB_EcSetSlaveState and I get the error: "target port not found" "possible causes: ADS Server not started" How...

I need to collect SNMP traps with my PLC (running win CE), since it's the only common comunication protocol with all the devices in my system, then I need to send a single SNMP trap from the controller to higher level. Beckhoff SNMP library will only send traps, so i was thinking about some...

The supplier answered the following: Compare read EDS with database... warning 1000: Object [1800sub1]: Default value differs from selected database (range: [$NODEID+0x180,$NODEID+0x40000180,$NODEID+0x80000180,$NODEID+0xC0000180]). warning 1000: Object [1801sub1]: Default value differs from...

Well yeah, usually they offer a training for every question you ask them. hehehe I already wrote them for the EDS file, and they sent me this... they just told me to ignore the errors of some SDO object ... that it can work therefore i have ommited the object 0x1000 and 0x1008, also the auto...

exactly, the file they gave me is wrong... therefore I need to find out how to configure the Box myself, so I used the trace obtained from the other controller and then I set the configurations accordingly. would it help if i also include the mentioned traces?

Hello, Im trying to configure a CANOpen master klemme (EL6751) to communicate with a device (Jetter JXM-IO-E09-G07-K00) in the System Manager, I have several problems, and the communication doesn't work, I explain what i did step by step. First of all the JXM works perfectly with a jetter...