Aktueller Inhalt von Badil

Automation studio problem Hi I'm going to build a project with B&R Automation Studio, But an annoying error in most part of the process appears: Ein Wechseln zwischen aktueller und angegebener Verschlüsselung wird nicht unterstützt. Error : on line 1, position 39 in "(null)" Translated to...

Hi I'm going to build a project with B&R Automation Studio, But an annoying error in most part of the process appears: Ein Wechseln zwischen aktueller und angegebener Verschlüsselung wird nicht unterstützt. Error : on line 1, position 39 in "(null)" Translated to english (no need for this forum...

georg_demmler Thanks for your consideration. But surprisingly no result for "ncation" in google. Waiting for others guidance. Regards

Experts in sps-forum have been always kind to me in solving some automation problems. Now I'm trying to diagnose some B&R servo motors and the goal is to build a B&R project for testing B&R motors. there is a list of what I have for this aim: - Acopos 1022 servo drive with AC 110 and AC 120...

Thanks oliver Your knowledge was very helpful for me. We have two of this machine in our field both with identical motor, I swapped the other motor with the faulty one, there is no fault. So I assume that the problem is with the motor. For the same reason it could not be cause of wrong...

Dear Knaller Thanks a lot Now I have not F248 error and just F228. How about this fault? Do you think I need to replace the encoder board? (that would be a tough choice) Is there any way to eliminate F228? Is F228 something like F220 and could not be eliminated? I can jog the motor without any...

Ralle Actually I think it is my problem could not write in dutch.

thomass5 Can you enlighten me more? What do you mean drive against the mechanical end of your axis? (I assume that you said it as a remedy of F228 fault) P.S. I have replaced the battery.

Ralle Yes, I've read it before. The remedies did not help. Is there anyway to get sure of the encoder board function? The motor is all right in jog operation, but when it is supposed to be in a specific position the error occurs after some sequence of moves.

Hi We have a DKC11.3-040-7-FW and a MKD071 servo motor The main problem is F228 error, after running good for some hours the error appears. Beside it every time the drive turn on, F248 (low battery error) appears (even when we use direct voltage (3.6) to the encoder board, so the battery is...

Zako Thanks I did your advise. Regards.

If I have possibility of contact an call, I never discuss it here.

Is anyway to update the indradrive firmware? Indraworks Ds have a choice for this, But it seems one must have the firmware file (*.ibf extension) to do this. Mine is FWA-INDRV*-MBP-04V42-D5-1-SNC-NN, and I think it can be upgrade to some FWA-INDRV*-MBP-05VRS-D5-1-SNC-NN. Is ther any link to...

Moin Knaller My drive is CSB01.1C-SE-ENS-EN1-L1-S-NN-FW type. As I said the drive can read S2 encoders, but with the same cable can not read S1 encoders (encoders with HIPERFACE interface) memory and I'm confused. Regards

Experts Hi I have a indradrive C HCS02 and a MSK100B-0200-NN-S1-BP0-NNNN motor with a SICK SKS36 on it. All of a sudden the drive can not read encoder memory with C0270 (error in reading encoder memory) I check the motor with my other indradrive C and it can recognize the motor with the same...