Aktueller Inhalt von Tabo260897

Yes the parameters COE are correct 115 kBits/s Led Rx/Tx flicker Green and orange At the output terminal El6022 in twincat, I can see correct byte values which corresponds with the ASCII string commands sent . So the comands are sent correctly , but i dont see a movement at the motor, and no...

Hello. I am building a cable to connect beckhoff terminal EL6022 and a Piezo PMD301 motion controller. The connector from EL6022 is a 9Pin Dsub Male. The side of Piezo motion controller is Stereo Jack 3.5 mm TRS cable. The communication set between them is RS485 . The data sheet of Piezmotor...