-> Hier kostenlos registrieren
Hello to all
I just started to learn PLC's. Please help me solve a problem I have been fighting for several days now. I am using a PFC100 (750-8100) controller and a three-phase counter 750-493. When I try to run any program on PLC, I get an error: "kbus driver has detected a configuration mismatch and locks start of application!".
Scanning modules in e!Cockpit displays my configuration without problems. I\O-Check also works. I can go into the 750-493 module settings and see the measurement values, voltage, current, everything looks good. I also updated the controller firmware to the latest version 02.08.35 (11), but this did not help.
I always get this error if the 493 module is installed. I tried to work with other DO\DI modules (a set of several dozen), and everything works without problems. But if I install 750-493, then I get this error again
What could be the problem?
I just started to learn PLC's. Please help me solve a problem I have been fighting for several days now. I am using a PFC100 (750-8100) controller and a three-phase counter 750-493. When I try to run any program on PLC, I get an error: "kbus driver has detected a configuration mismatch and locks start of application!".
Scanning modules in e!Cockpit displays my configuration without problems. I\O-Check also works. I can go into the 750-493 module settings and see the measurement values, voltage, current, everything looks good. I also updated the controller firmware to the latest version 02.08.35 (11), but this did not help.
I always get this error if the 493 module is installed. I tried to work with other DO\DI modules (a set of several dozen), and everything works without problems. But if I install 750-493, then I get this error again
What could be the problem?