-> Hier kostenlos registrieren
Google translate:
Hallo
Verwendet jemand plcopen-Bewegungssteuerungsblöcke zur einfachen Steuerung von Motoren mit Frequenzumrichter? Ie. für eine Pumpensteuerung mit MC_MoveVelocity zur Drehzahlanpassung
Dies hätte natürlich einen gewaltigen Aufwand im Vergleich zu der Funktionalität, die ich brauche, aber es scheint sehr praktisch zu sein, die Abstraktion zwischen plc / nc / drive, Fehlerüberwachung usw. zu erhalten. Vor allem, wenn EtherCat und CanOpen verwendet werden, bei denen die Zuordnung von Drive zu Axis zu sein scheint ist so ziemlich Plug and Play. Irgendwelche Gedanken?
Original text:
PlcOpen Motion for simple start/stop and speed adjustment
Hi
Does anyone use plcopen motion control blocks for simple control of motors with variable frequency drive? Ie. for a pump control using MC_MoveVelocity for speed adjustment
This would of course have huge overhead compared to the funcionality I need, but it seems very convenient to get the abstraction between plc/nc/drive, error monitoring etc. Especially if using EtherCat and CanOpen where it seems like the mapping of drive to axis is pretty much plug and play. Any thoughts?
Hallo
Verwendet jemand plcopen-Bewegungssteuerungsblöcke zur einfachen Steuerung von Motoren mit Frequenzumrichter? Ie. für eine Pumpensteuerung mit MC_MoveVelocity zur Drehzahlanpassung
Dies hätte natürlich einen gewaltigen Aufwand im Vergleich zu der Funktionalität, die ich brauche, aber es scheint sehr praktisch zu sein, die Abstraktion zwischen plc / nc / drive, Fehlerüberwachung usw. zu erhalten. Vor allem, wenn EtherCat und CanOpen verwendet werden, bei denen die Zuordnung von Drive zu Axis zu sein scheint ist so ziemlich Plug and Play. Irgendwelche Gedanken?
Original text:
PlcOpen Motion for simple start/stop and speed adjustment
Hi
Does anyone use plcopen motion control blocks for simple control of motors with variable frequency drive? Ie. for a pump control using MC_MoveVelocity for speed adjustment
This would of course have huge overhead compared to the funcionality I need, but it seems very convenient to get the abstraction between plc/nc/drive, error monitoring etc. Especially if using EtherCat and CanOpen where it seems like the mapping of drive to axis is pretty much plug and play. Any thoughts?